Swaging Machine to Preset Ferrules Onto Tubing | Model PS20

Product Description

The PS20 is a bench-mounted high volume swaging machine designed to preset ferrules onto a single piece of tubing. Winton Machine's swagers allow your operation to drastically reduce cycles, saving time and increasing safety.

The swager makes use of a concentric guided motion that draws down on the nut forcing the ferrule(s) into the presetting body. Each preset body comes with a build-in hard stop that sets the depth so that each crimp is consistent, part to part and lot to lot.

Details: PS20 Swaging Machine

  • All pneumatic device most often used to preset ferrules onto a stainless steel tube
  • Interchangeable tooling allows for manufacturing flexibility
  • A hard stop prevents the system from over crimping a ferrule assembly
  • Consistent presetting – hour after hour, day after day
  • Easy access cycle start switch
  • Bench-mounted
  • Change over from one size to another in < 30 seconds
  • Optional on touch auto-cycle start switch available (120 VAC required)
  • Optional floor stand available
  • Optional low air pressure alarm (120 VAC required)
  • Optional dual palm start switches available (120 VAC required)
  • All assembly documentation included
Product Details


Weight (w/4 stage pneumatic power)

74 lbs.

Dimensions (L x W x H)

10” x 10” x 23-1/4”

Air pressure required

80 PSI


Ø3/4 “x .028” wall aluminum w/2 stage cylinder

Ø1/2” x .065” wall stainless steel w/2 stage cylinder

Ø3/4” x .065” wall stainless steel w/4 stage cylinder


Typical cycle time

3 seconds

Preswage your nut-ferrule sets